AutoEnginuity with Ford, GM, Dodge, & Chevrolet Enhanced

• PATS Timed Key Programming (’96 – ’08)
• KOEO
• KOER
• Power Balance (CAN-based models)
• EVAP Bay Test
• Service Bleed (Non-CAN support not available with ProLine currently)
• Buzz Injector
• Cylinder Contribution Test
• Switch Test
• Glow Plug Test
• System Self-Test
• Low – and High Speed Fan
• All Outputs On/Off
• Injector Coding (1.8L and 2.0L)
• KAM Reset
• Misfire Monitor Neutral Profile Correction
• Tire Size Programming up to 40″ (’99-’03 7.3L, and ’04-’07 6.0L trucks)
• IVD Initialization
• Steering Angle / Yaw Rate / Acceleration Sensor Reset (’03 Explorer and Lincoln LS)
• Passenger Seat ReZero and Passenger Weight Reset
• Power Seat Calibration Test
• Audio Network Communication Test
• Vehicle In-Motion IO Test
• Front Wiper Self-Test
• Rear Wiper Self-Test
• Diesel Particulate Filter Reset, Clear EGR Adaptive Tables, and Clear Fuel Injector Adaptive Tables

GM Family – Includes support for Buick, Cadillac, Chevrolet, GMC, Hummer, Oldsmobile, Pontiac, and Workhorse. Over 6,000 sensors from over 68 systems is supported. There are over 2,000 bi-directional command and system level tests that can be performed!

• ABS Automated Bleed Routine (ProLine Connector)
• Crank Variation Learn
• Injector Flow Rate Programming (CAN-based Diesels)
• Key Fob Programming
• SDM Setup and Part Number Programming
• Idle Learn
• TDC Learn
• Tire Pressure Sensor ID Programming (via CAN-based Remote Control Door Lock Receiver)

Chrysler/Dodge/Jeep – Coverage includes diesel Cummins engines, Dodge Sprinters Vans, and much more!

• EGR System Test
• EVAP System Monitor Service Test
• Erase All DTC Fault Codes
• Generate Full Field Test
• Gov & 3-4 Shift Valve Test – JTEC Only
• Leak Detect Pump Test
• Purge Vapors Test
• Reset All Adaptive Memory Fuel Cells
• Reset All Non-Volatile Memory
• Reset CAM/Crank Misalignment
• Reset CAM, Crank, and Sync Status Record
• Reset Duty Cycle Monitor
• Reset Engine Running Time Record
• Reset Fuel Shut-off Record
• Reset Intake Airflow Control Stepper Motor Position
• Reset Trip Information
• Set Sync Signal – JTEC Only
• Set Minimum Throttle Position to Maximum
• Torque Converter Clutch Test – JTEC Only